
The removal of standing water from a property, done fast enough to limit what the water reaches next.
Emergency water extraction is the first step after a burst pipe, an overflowing appliance, or storm water entering a property. It is the removal of standing water before that water has time to travel further into the building.
You need it when there is visible water on the floor and it is still spreading. A supply line that let go while nobody was home, a water heater that failed overnight, or a condensate pan that overflowed into a hallway all produce standing water that keeps moving until someone removes it.
Extraction is the opening phase of water damage restoration [Water Damage Restoration], which continues with drying and repair once the standing water is gone.
Emergency water extraction is the first step after a burst pipe, an overflowing appliance, or storm water entering a property. It is the removal of standing water before that water has time to travel further into the building.
You need it when there is visible water on the floor and it is still spreading. A supply line that let go while nobody was home, a water heater that failed overnight, or a condensate pan that overflowed into a hallway all produce standing water that keeps moving until someone removes it.
Extraction is the opening phase of water damage restoration [LINK to Water Damage Restoration], which continues with drying and repair once the standing water is gone.
Extraction equipment is matched to the volume of water and the surfaces involved. Portable units handle confined areas and upper floors, while higher capacity equipment is used where the volume is greater or the run to a drain is longer.
The work goes past what is visible. Carpet and padding hold significant water that a surface pass will not lift, so extraction tools are worked into the material rather than run across it. Water travels under cabinet toe kicks, beneath appliances, and along the base of walls, and those spaces are addressed rather than left.
Conditions are photographed before extraction begins, and moisture readings are taken so there is a record of what the water reached before any of it was removed.
The source is shut off if it is still running, and electrical safety in the affected area is confirmed before anyone begins working.
Photographs and readings are taken first, because once extraction starts the original conditions cannot be shown again.
Extraction begins at the furthest point and works back toward the source of the loss, so water is not pushed into dry areas during the process.
Walls, cabinet bases, and subfloor are checked for absorbed moisture, which determines what the drying phase needs to address.
Here are answers to common questions about our restoration services.

As soon as possible. Water continues spreading and absorbing into materials the entire time it sits, so the affected area grows by the hour rather than staying where it started.
For a small spill on hard flooring, often yes. A shop vacuum cannot pull water out of carpet padding or from under cabinets, which is where most of the water ends up after a larger loss.
No. Extraction removes standing and absorbed water. Drying removes the moisture left inside building materials afterward, and both are needed before a property is actually dry.
Yes. Our crews in Doral work 24 hours a day, seven days a week, because water losses frequently happen overnight and waiting until morning costs materials that could have been saved.
Drying begins. Equipment is placed based on moisture readings and monitored until the structure reaches dry standard, then any material that could not be saved is removed and replaced.
8400 NW 33rd St, Doral, FL 33122
+1 813-921-2308
8400 NW 33rd St, Doral, FL 33122
+1 813-921-2308